Compadre Mod

[WM6]

Thank you KT315.

There are no picture in old thread "Tesoro Compadre modification - easy" anymore.

My version of Compadre are equipped with additional volume knob.

Will see what additional sensitivity knob can do.

[BVlad]

Hey, can anybody help me with the maxboost resistor for my compadre? I have already installed the 10k pot and it works well but there is no boost in depth. I Just dont understand where to connect 1k resistor for Maxboost?

P.S. I Have a new revision of compadre pcb (4.1)

[kt315]

you think are there only all idiots in Tesoro company sitting down? if they can they would be made this mod without any doubt.

[peterr88]

I have made this mod and it worked out great for me

[bernte_one]

latest work

[Pinpoint]

I have done some mods on this, added sens and GB, does anyone what the third trimmer does? My soldering wasn't the best, not sure how to solder onto those pads once the trimmer was removed but I got the job done, if I take the faceplate off I'm afraid the solder might break...

[SVEN1]

Discrimination preset. I haven't played with this pot, so I don't know how this will effect the Comp.

[Kjamesgraham]

That stem mod is bad ***!

[kt315]

Hello KT315,
Hope you are having a good day my friend. I was reading some older posts about the Tesoro Compadre as I purchased one and it works well. Looking through the Geotech posts about the Compadre I came across a post about the ( ground balance tone)?? I have never heard of this and would you know what this is and what it does? I am still looking for a quality schematic as the one I saw posted on Geotech doesnt look good when enlarged as its blurry. But any info you might have on the Tesoro Compadre ground balance tone, and what its purpose it would be very very helpful. Thank you again for all of your assistance and your time and I hope youo have a great day. Take care and talk soon my friend...
Frank

first of all i must get pics of board of highest resolution. read my opus http://www.geotech1.com/forums/showt...here-share-out
SORRY I REMINDER THAT EVERY TIME BUT I MUST. PEOPLE DO NOT WISH TO STUDY -!
second, we must to think how add ALL-METAL mode just compadre has not this mode. be cause to tune ground balance needs ALL-METAL mode.
third, you must have high level to solder SMT components because you will meet the board opened just in SMP. without this practice nobody is able remotely moving your hands.

[kt315]

OK.

no pics from your side - no answer from my side. if you are NOT cooperative and do not wish be cooperative so WHY YOU ASK ME????
main forum rule is EXCHANGING OF INFORMATION IN TWO DIRECTIONS!

matter CLOSED!