Baracuda Schematic

[paku]

Is that Any One Have Clear Schematic For Baracuda

[Silver Dollar]

How about this one?

[paku]

How about this one?

You Are Thanks SilverDollar I Want Try Rip This Schematic

[DOOLEY]

not sure if you should trust that schematic,
quite allot of values of resistors have been "doctored" / changed to "silly"
values,
also the 555 configured all wrong, itll go pop !!!
it's poss a "spoof" schematic..........

check out resistor values around the 5534 and u2a and u2b !!

pin 3 of the 555 goes to "earth" !!!

and the 220uf between reset and trigger made me laugh, a bit !!

[paku]

hahaha yea bro thanks i just want view and see the match with other schematic then i will try replace and change the part to other part to make it stable
and i also rematch it with surfmaster schematic

[DOOLEY]

here,
try this schematic,
it's the clearest one I have found,
had a quick look over, haven't spotted anything.........



oh, since compared the other schematic to this one......
the 555 on the top right supposed to be a 7660,
which, unless you have the high voltage version it won't like
12v's going in to it.

[kt315]

the sch

[kt315]

[paku]

kt315 in your schematic remove the read mark, and the board have empty hole, leave it empty ?
or what
sorry my stupid question and my very bad british english :d

[kt315]

your posting is undecipherable for me. can you write in international comfort english?

[paku]

hahaha sorry my bad english

[paku]

at pin U3 IC 7660 Pin 5, Some Schematic have Resistor 270K, or 10R other schematic have direct without resistor which is true

[paku]

the schematic and the part placement on pcb layout is much rong

[kt315]

seems a time to create new thread Just started to build Bara

[bernte_one]

best resolution shematic i have for the moment
just change the partnumbers if you find some parts which a not same on the actual layout

thats not critical, follow the legs / pins of the integrated circuits and you will find what you want to know