If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I did put the scope on it today and it seemed ok and there was no noise but I did not go in to much detail, Interestingly if I look in detail at what is read vs the actual hex there is some minor errors so I am wondering if this could be a noise issue or something. ultimately I may have to try another programer this clone could be a dud.
Try a different value of Resistor pulling up the MCLR pin. Eg 1K then 100K Also try and program it with no resistor at all on the MCLR.
Tweet
Comment