Resistor Values P1 VS P2

[WesP]

Gary,
I'm putting together a PII board and noticed that the parts list shows R12 and R14 as 680 ohm but the parts overlay shows these as 220 ohm. Which one do you recommend I use? My PI is working fine. I haven't mounted it for field trials yet as I'm still winding diffrent coils looking for the best performance.

[chemelec]

The correct resistance really depends on the coils your using.
Values between 100 Ohms to 1000 Ohms are suitable.
Typically I supply and use 680 Ohms for most of my coils.

(Not sure Why I put that 220 Ohms on that overlay and I should Change it.)