Tweet
Originally posted by kt315
View Post
Thank you for the BOM
-
Thank you for the BOM -
-
-
The 10,7 is from from measure point. T2 and t3 .The normal battery source is 12v, tomorrow I will post you some pictures to see if I am okComment
-
Also I will change the battery and I will make new coil with correct resistance and mh tonight tomorrow I will post you resultsComment
-
T2 and T3 are impulse signals. no sense to measure them by a tester because it will show absurd values.Originally posted by Kubi2323 View PostComment
-
no sense to measure coil resistance in PI system because it is very small, units of Ohm.Originally posted by Kubi2323 View PostComment
-
If I don’t measure the coil resistant and the mh value how I will make the new coil?? The old coil that I have it’s from another device the ohm 3,7 and the mh 680 the performance on this pi is not good need new coil for sureComment
-
Tomorrow I will send you pictures so you can understand what I meen.
i have one question 1x1 coil what is the maximum performance of this device???Comment
-
mh you write/(operate by) is MILLI-. you have to get uH - MICRO-.Originally posted by Kubi2323 View Post
we mean/(say about) 350-500 uH range.Comment
-
you bought pcb on ebay. ok? in my listing there is (THERE IS) the original banner of German Company WITH PERFOMANCE LIST,Originally posted by Kubi2323 View Post
in german and english.
why you see and not able to see??? https://www.ebay.com/itm/333670263939
i can add nothing to this banner because its 'Standart'.Comment
-
Yes that is my mistake I mean uh not mhComment
-
please learn electronics basics on something another. i see you try to learn it on delta pulse, with zero level.
i am NOT teacher in school and a professor in US tech university. LEARN YOURSELF. if you want 'unlimited depth'
go in parallel universe - https://www.geotech1.com/forums/foru...geLocators-com
DP has LIMITED depth. yes, good, but limited.Comment
-
Thank you for your help and you are write i will go in parallel universeComment
Comment