Introduction

[Carl-NC]

HH-2 is closely derived from HH-1, but uses a PIC micro for timing control. Since there are few changes except for the PIC and the demands of the PIC are fairly light, this is a good platform for those who are just getting started with using micros in their designs.

[GOMOS]

New version Hammerhesd II?

Hi All,

Is there a newer version of the publication Hammerhead II.
I have the manual for version HHv1p5, and the PCB have to RevA20Jun09.
If so, please e-mail it to or where you can download it.
Thank you and best regards.
Gomos

[Carl-NC]

Is there a newer version of the publication Hammerhead II.
I have the manual for version HHv1p5, and the PCB have to RevA20Jun09.

I never wrote a guide for HH2, so that was the last version.

- Carl

[alihaji20002]

hi guys,
i am new in this forum and looking for "text" that mentioned in the schematic diagram of HH-II-PI :
"See text"
but i did not find any documet or explanation text in this thread.

where i can find it ?

best regards
ali

[Carl-NC]

The 'text' for HH2 was never written. See the HH1 document for as much written info as I have.

[Dino Sauce]

Hi, my name is Bryan from AU.
I look forward to exchanging ideas and discussion topics with all of you. Please excuse me in advance if I seem blunt or terse at times, or make spelling mistakes. I've learned a lot here already just lurking around, but this forum helped me so much.


Kudos!