TO Carl: PI-1 & Hammerhead PCBs

[Dennis Line]

Hi Carl,
I have been off-line for the last month. Could you tell me the status of the PI-1 & Hammerhead PCB. Are they available yet? I would still like one of the originals. As well as the new SMT board.

Regards,
Dennis Line

[Carl]

Re: TO Carl: PI-1 & Hammerhead PCBs

I had wanted to simplify the design a little bit, before sending out for more boards. When I simplified the schematic, the resulting changes to the PCB left some gaping holes, so I thought, why not pack it in & reduce the size? Easier said than done. It would be easier to start a new PCB from scratch.

If I can't finish it up in the next week or two, then I will just send out what I have. The SMT board is good to go, so I can get those made, although there was only a handful of folks interested in that.

- Carl

[tparker]

Re: TO Carl: PI-1 & Hammerhead PCBs

Will the Hammerhead be in a kit and if so how much will it cost?
I would like to build one.

[Carl]

Re: TO Carl: PI-1 & Hammerhead PCBs

No kit, just the PC board. Parts are easy to find. PCB will probably remain $10 shipped.

- Carl

[tparker]

Re: TO Carl: PI-1 & Hammerhead PCBs

Can you email me mailing address so I can order on of your boards And can I post test and info on the hammerhead on my website(www.firstontop.com) after I Build it.How do you want me to pay for the board? money order etc.

[Carl-NC]

Re: TO Carl: PI-1 & Hammerhead PCBs

>Can you email me mailing address so I can order on of your boards And can I post test and info on the hammerhead on my website(www.firstontop.com) after I Build it.How do you want me to pay for the board? money order etc.

I am out of boards right now, send me an email and I will let you know when I get more boards, or watch here for an announcement.

- Carl