More info on SMD hammerhead

[PhilippeM]

Hi Carl,
Can you give us more information about the Hammerhead SMD: option?? Bill of material?
A bigger vue of the placement as the writting on the PCB are very very small.

Thanks a lot
PhilippeM

[Carl-NC]

Re: More info on SMD hammerhead

I have just uploaded the SMT parts placement diagram to the HH project page. I will try to work up a BOM over the next couple of days. Schematics for the 2 options should be valid for either thru-hole of SMT.

Sorry for the delay, let me know if you need anything else.

--Carl

[PhilippeM]

Re: More info on SMD hammerhead

Hi Carl,
What Schematic can i use for the smd card?
Is it option 1 or Option 2 ?
IS the same schematic that the Thru hole?
I don't think as the schematic driving of Q3 is not the same as the schematic found on the project folder!
Can you give us information about this ?
Thanks a lot
regards
PhilippeM