Coil shield and coax cable

[PPG78]

Hi!

I have a question to ask. When we look the schematic diagram of the HH we see that one end of the coil is connected to ground - to the same ground where the shield of the coil is connected.
What is better, to use "standard" coax cable and connect the shield and one coil side together or to use stereo coax cable and join the connections at the PCB side?

Best regards, Peter

[Carl-NC]

I think at the level of this design, a std coax cable if fine. For a really sensitive design, a double shielded cable, or a shield twin lead might be preferable, but I'm not sure it would make any difference.

- Carl