C27 electrolytic or poly?

[Coe42]

In the schematics and parts list it shows as electrolytic (47 uF) but in the board (Rev C1) the place for it is for a SMT capacitor... What should I use?

Thanks!!!

[Carl-NC]

Apparently there was a numbering snafu... C27 on the SMT is a completely different cap than on the thru-hole. Use 1n.

[Coe42]

Never mind...

There is a typo, probably is mentioned somewhere in the old posts in the forum. C27 in the board is C11 and where it should say C27 says C28. I guess C11 is not used?

Thanks!

David

[Coe42]

Apparently there was a numbering snafu... C27 on the SMT is a completely different cap than on the thru-hole. Use 1n.

Ops! I was writing while you were answering!

Thank you Carl, you have answered my question. C11 is used and is 1nF