If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Pay particular attention to shielding method and use shortest possible cable to minimize capacitance. Be sure to make a relative small diameter coil, ~270mm maximum diameter, smaller would probably be better.
You might also change preamp feedback resistor R13 for lower gain to help the amplifier recover more quickly. Try 470kΩ.
Use short pulse width tx signal and increase PPS frequency.
There are some other things you could try but I could not suggest them unless you tell me you have a dual trace oscilloscope. Modifications often have unintended consequences. You could modify one thing, then something else needs adjusting because of it, and so on and so on.
hi dear all
hammerhead pi 1 not volume speaker opt 1 non voltage controller audio all power supplies no problem any problem has for audio power amp parts
Comment