TGSL and IGSL Schematic File

[BKY1337]

Hello,

has somebody the .sch file for the Tesore Golden Sabre (Light) and/or the IGSL?

I want to make a smaller board with Kicad and im too lazy to draw everything new.

[Davor]

Both projects are done in ExpressSCH. I think you can export a netlist to work with other software.
Right now IGSL is under a serious revision, so be a bit patient.

[BKY1337]

I downloaded Expresspcb but i need the files too.
The file from the IGSL thread seems to be damaged.

I dont think that i can make the IGSL smaller, but maybe the TGSL a bit.

[bernte_one]

http://www.geotech1.com/forums/showt...950#post237950

[BKY1337]

Thank you Bernte! Unfortunately is this schematic without pin numbers and component ID's.

I still need the schematic from the TGSL EDU Silverdog boards.

[homefire]

Go to the Project. All is at hand.

[BKY1337]

I cannot find a .sch file from the TGSL in the sticky thread.
I want to make it smaller than 100 x 100 mm.

[Nandor]

Schematic.pdf thats the file you are looking for. You have to redraw it in ExpSchematic. Also there is a Gift Pack in the TGSl topic there you will find the sch. file.

[Nandor]

If you search the TGSL topic you will find everything you want, there is no need for making new threads asking the same thing every time. TGSL topic has +200 pages there is everything! everything you need, mods, prototypes, different versions just take your time and read it.

[BKY1337]

I already wrote that i dont want to redraw the whole schematic in a program.
I searched the whole day for the files.

I think i will use the smd version and i gonna replace the solder pads with holes for the resistors.

Thanks anyways.

[dbanner]

Here is a .sch file that opens in expressSCH

[yatahaze323]

Hi BKY1337, I attempted to shrink the TGSL in Sprint layout to 100mm x 100mm. I just posted today asking people to look it over to make sure I didn't break anything with my changes. If I get some people to confirm that it looks good then I'll post the gerber files and sprint layout so it can be used on the pcb printing sites.

[BKY1337]

Thank You dbanner!

I can open it and link it to the pcb in expresspcb but i dont know how i can create a netlist from it. Do i need to make it with expressSch or with expresspcb?

I think Kicad and Eagle cannot open this file.

And good work yatahaze323 . I will take a look at it and im interested in the files.

[BKY1337]

Okay, yatahaze323 , i saw that you only removed a part of the filled copper area, so i think it will work.

I think it is possible to make it even smaller. I want to use the silverdog or the smd version for this.

[Nandor]

Good luck, it's not so easy.