Can the IB-PI differentiate between metals?

[nick_f]

Tinkerer,

Could you please provide some construction details for your coil? Some photos would be good too.

Regards,
Nicolae

[Qiaozhi]

It would be very interesting to hear all the other advantages and disadvantages that you found, when experimenting with the IB coil.
There is so little information on the forums about IB coils.

Tinkerer

This was an observation I made some time ago.
I've sent you an email.

[Tinkerer]

This was an observation I made some time ago.
I've sent you an email.

I did not get the email. Please send again.

Thanks

Tinkerer

[Tinkerer]

Tinkerer,

Could you please provide some construction details for your coil? Some photos would be good too.

Regards,
Nicolae

Hi Nicolae,

For TX, I will start using the coil described at:
http://www.geotech1.com/forums/showthread.php?t=15383

For RX I will wind a new coil with about 180mm diameter and 300uH.
I will take pictures during the coil construction and discuss the reasons for the method of construction used.

Tinkerer

[Qiaozhi]

I did not get the email. Please send again.

Thanks

Tinkerer

Sorry, there's a problem with my email at the moment, and its stuck in my outbox. Hopefully the problem will be fixed soon.

[Tinkerer]

Hi Nicolae,

For TX, I will start using the coil described at:
http://www.geotech1.com/forums/showthread.php?t=15383

For RX I will wind a new coil with about 180mm diameter and 300uH.
I will take pictures during the coil construction and discuss the reasons for the method of construction used.

Tinkerer

FULL STOP ON THAT.

hobbes suggestion of a coil that fits into a standard 8" coil housing is much better. So I will also build a complete new coil myself. Will post all the details.

Tinkerer