coil cable distancer

[Funfinder]

Depending on the shape of the detectors handle
or grip a coil cable distancer could be very useful.

Otherwise the cable could get touched by fingers or
hand instead of remaining in a notmoving, safe position.

For the Blisstool I have used one of those bike-lamp-holders
in combination with a special part fully made out of rubber-gum.
It contains a small fissure for simple plugin in or removing the cable.

[Funfinder]

After some hours of real testing I found out that the position of the distancer
is improvable. Because this cable has some tension and after a short time it
starts to touch the upper side of the hand. But not with the new position!

Important: It's the best to wind the cable from the coil directly beginning
over the stem (from where the cable is attached at the coil it looks like
a bridge until it touches the stem on the opposite; This is the better
method anyway cause the coil cable directly goes better upwards)

The angle is 45° and the min. distance pole<->cable 3.5cm (1.5'').