new coils from spain

[bernte_one]

Hello,

after searching the net i found nice solution for most diy Projects here
baracuda, surf, hammerhead and the other fast pi designs (maybe Sven1 Mirage pi)

http://www.lightanddeep.com/producs/
if you scroll down you can find model for vandal 3 pulse from Sinko (crazy tech net)

dont know anything about Prices and shipping but they look professionel and i hope they are not expensive
best regards

[pjrough]

The price is 40€ + shipment.
The coil is waterproofed.

these are Characteristics:

• [*=1]Coil: 500 uh
  [*=1]Drain Resistance: 330 ohm
  [*=1]wire diameter: 0,5 mm

I am new to the forum, wherefore I have doubts whenever the parameters are ok to use this coil with surf pi. Please advise.

[bernte_one]

Hello,

first collect coil datas here in forum for the different projects.
Surf Pi is best between 270-300µH (same as you offer for vandal pulse), but without pre-intalled resistor
Damping Resistor is placed on pcb of detector and not in coil body

How much is shipping to germany?

[pjrough]

Hi, you got me wrong, I am not a seller, I just wanted to use this coil for my surf pi project.
But from your answer I saw, that it is not optimal solution. Am I right?

[multieagle]

I hooked one up to the Crossbow, and works fine.

[bernte_one]

hello multieagle,

did you order one coil from spain? i got no Response from shop owner
can you post a Picture from your crossbow pi and the 300µH coil?
thanks and best regards

[multieagle]

Will not work on the Surf PI.

[bernte_one]

300µH coil for vandals pulse 3 should work, but as i understand there is a pre-installed resistor

[multieagle]

The coil is 500uH. It works fine on the Crossbow, as that is the suggested range.

these are Characteristics:

Coil: 500 uh
Drain Resistance: 330 ohm
wire diameter: 0,5 mm