help with coil

[folharin]

Can anyone give me details of how to pass this resin, the mold is made of wood, is there any product between the wood and the resin?

[homefire]

I'm not sure what the question is.

[ivconic]

[ATTACH]39096[/ATTACH]
Can anyone give me details of how to pass this resin, the mold is made of wood, is there any product between the wood and the resin?

Oil or grease i suppose.
If i understood correctly; you are asking how to prevent resin sticking to wood, right?
I guess is alright to smear simple "machine" oil over wooden surface and primed it with some brush or sponge equally.

[homefire]

Ok, Got it. Healthy spray with Dry Silicon Spray works for me. https://www.walmart.com/ip/3M-Silico...&wl13=&veh=sem

[ivconic]

Ok, Got it. Healthy spray with Dry Silicon Spray works for me. https://www.walmart.com/ip/3M-Silico...&wl13=&veh=sem

Even better!

[BKY1337]

This is a mold for vacuum forming not for resin.

[kosacid]

use a candle and rub it into it or melt the wax and cover it

[folharin]

thanks

[dfbowers]

If I understand the question.. It's pretty easy to extract the wood form from the plastic.. I have done it many 100's of times. Try this:
Build a square frame out of 2 × 4s about the same size as your ABS sheet. Then just bang your plastic against the frame until it pops out. You can help this process by building your form with a slight taper everywhere.

I generally put a soft pad in the bottom of the frame so my form does not get damaged.. but it's very difficult to damage ABS.
Don..

[Metalmatt]

When you form the shell its easier to remove form when the abs is still slightly warm. I drive a screw partially into the wood and pull with pliers.
I also rub candle wax into the wood and it pops right out.
MM