Tweet
Hello
Dear sir.
I hope you are doing well and forgive me for my Email.
Actually, I followed your technical posts in Geotech about Hammerhead 1.
Before everything, thank you for your sharing info.
Actually i have built HH1 Rev. C and tested it with the GPX 11" commander coil. I tested its damping resistor (without any damping and with 189-100K) and finally reached 10K (However, its sensitivity is not very noticeable) but my sensitivity still is very low. Do you think there is any tip to do for reaching high sens like TDI with GPX coil? I opened TDI and saw its PCB (attached), it also has used 1K for RX coil. Can you tell me how to use GPX coils in HH1 with high sensitivity like TDI SL?!
I hope you accept to help me����
Thank you my friend.
----
ok. why Farz you do not want to share out the pics of high resolution? you are now silent. SILENT!
while you was much active! do your home work best and you'll get best answers,
this is SIMPLEST RULE.
Dear sir.
I hope you are doing well and forgive me for my Email.
Actually, I followed your technical posts in Geotech about Hammerhead 1.
Before everything, thank you for your sharing info.
Actually i have built HH1 Rev. C and tested it with the GPX 11" commander coil. I tested its damping resistor (without any damping and with 189-100K) and finally reached 10K (However, its sensitivity is not very noticeable) but my sensitivity still is very low. Do you think there is any tip to do for reaching high sens like TDI with GPX coil? I opened TDI and saw its PCB (attached), it also has used 1K for RX coil. Can you tell me how to use GPX coils in HH1 with high sensitivity like TDI SL?!
I hope you accept to help me����
Thank you my friend.
----
ok. why Farz you do not want to share out the pics of high resolution? you are now silent. SILENT!
while you was much active! do your home work best and you'll get best answers,
this is SIMPLEST RULE.
Comment