XLT Coil

[Geo]

Hi.
I have a XLT Coil that have problem with the shielding.
Does any knows a good way to open it without to destroy it ????
Regards

[kt315]

hi geo,
if you have the problem with shielding why you so necessarily need in the opening??? IMHO you can carefully pink a box (deeply!) near a cable input by your tester (sharp) probe and measure IS THERE A RESISTANCE OR NOT, between with the cable shield. remember that you must do it on both covers/parts of coil - on bottom and on top.

hh

[Geo]

Thanks KT315. The problem is that when i touch the coil cable then i have beeps. If i connect a new coil the problem is disapeared
I will try your solution
Regards

[kt315]

I think your problem is not in shield... try clean up and bend contacts in connector.

[Geo]

Btw how i can open this connector ???
Regards

[plboy]

if you thing the conector is fault - cut the cable near to connector than you can the rings the pins

[Geo]

if you thing the conector is fault - cut the cable near to connector than you can the rings the pins

Hi. What are you mean "you can the rings the pins" ??
Regards

[plboy]

if you cut the connector .... ringing - to know which wire on which pin are in the connector ...

[Geo]

if you cut the connector .... ringing - to know which wire on which pin are in the connector ...

Ok, but i don't like to destroy the connector or the coil

[kt315]

http://www.switchcraft.com/products/connectors-50.html
press on a latch then pull out the parts!

[Geo]

http://www.switchcraft.com/products/connectors-50.html
press on a latch then pull out the parts!

I Do it but without results
Anyway KT315.
Thanks

.... i will try it tomorrow again with more press