calculate coils

[cimiuac]

hello I need some help to calculate some coils for the magnetic therapie.
in the last time i am surching sone schematics to build the electro magnetic pulser generator and I like to know to kalculate the coils.
somebody can help mi with this project.
thanks

[Unregistered]

The pulsing coil you refer to is using a 10 milliHenry coil. The original was wound on a videotape spool & then wrapped with electrical tape. Not very high tech. For more information on a medical magnetic pulser please join the yahoo group: Beck-n-stuff. It will pay you to search the email archive for the group after you join. The old emails contain all the information that you need. The groups' email is [email protected]

You can use Wheeler's Formula to calculate the size etc. as shown at the following webpages:
http://www.hills2.u-net.com/electron/induct.htm
http://www.microwaves101.com/encyclo...ductormath.cfm
http://www.icorp.net/users/kev/tesla/form.txt

[Unregistered]

Direct link to Yahoo group:
http://health.groups.yahoo.com/group/Beck-n-stuff/

[Esteban]

hello I need some help to calculate some coils for the magnetic therapie.
in the last time i am surching sone schematics to build the electro magnetic pulser generator and I like to know to kalculate the coils.
somebody can help mi with this project.
thanks

I think the better is coil type belt. Disk irradiate but no much as belt. This belt is 90 cm long. I build this for bone treatment for football club. Coil is special and some critic in form of belt. You use here multiple coloured paralell common cable (type belt). I built two versions, disk and belt, and kynesiologist told me that belt is much better and cure very rapid fisures in bone.

I'll search the constructional steps if you want and post here.

Regards

Esteban

[tiktak]

Hi,

Hi,
Can someone calculate coil DD 37 for TGS?
Until now we have DD22;DD27 that are working good.
The interesting thing here is that we can use RHs trick with windings and use 30cm round former then shape it like D.
So how much winding do I have to use for TX and for RX with this setup,so I can reach same resistance and inductance.
Thanks