Delta Pulse2 coils

[Hasse]

Hello!

A friend of mine rode through the Delta Pulso2 forum, I made a coil
not getting a good result.

Coil covers a 40cm diameter 0.5 mm, 23 turns, 680mh, 2.7 ohms

the 2nd 40cm covers 0.5 square mm, 23 turns, 840mh, 3.4 ohms

Which of the two theoretically would work better?

thank you

[Jose]

Hello!

A friend of mine rode through the Delta Pulso2 forum, I made a coil
not getting a good result.

Coil covers a 40cm diameter 0.5 mm, 23 turns, 680mh, 2.7 ohms

the 2nd 40cm covers 0.5 square mm, 23 turns, 840mh, 3.4 ohms

Which of the two theoretically would work better?

thank you

I think of 680 uH have to work very well. Try different values of R5 (damping resistance).
Jose

[Hasse]

I think of 680 uH have to work very well. Try different values of R5 (damping resistance).
Jose

Thank you for answering Jose

I will follow your advice, but how can I increase R?
Prepending a resistor?
Pardon for my ignorance!
From already thank you

[Jose]

Thank you for answering Jose

I will follow your advice, but how can I increase R?
Prepending a resistor?
Pardon for my ignorance!
From already thank you

Placing resistors in parallel for different values and test the performance of the DP.
Example, (1K+2.2K), (1K+1.8K), (1K+1.5K), (1K+1K), (1K+820) ..... etc
The value is critical and usually depends on the construction of the coil. We must have patience.
regards