DIY Trash coil for LOBO Super Traq

[UFO]

Hey guys new member here.

I want to build a small coil for my LOBO ST. Maybe 4" to 6" diameter.

I think I could calculate the inductance for the new coil, however I don't know what the original coil is. (I don't have inductance meter)

I tried to search but got multiple answers, most were not for the newer super-traq version.

I understand that its the same coil on other models of Tesoro?

My connector has 4 pins.

Anyhow glad I found this place.

[FOMA]

Here is the method by which You can make your coil.

http://www.geotech1.com/forums/showthread.php?t=18582

Here are the data of the coil Lobo, Tejon, Vaquero (one and the same).

Rx 1-3 r = 4,0-4,3 om f(10H)=48,4-48,7 kHz
Tx 2-4 r = 63 - 66 om f(10H)=12,05-12,11 kHz

From these data can make the coil of any size and shape.

[UFO]

Thanks FOMA, I was looking at your device and thin I will build it.

I am a little lost on the "f(10H)" part, is that the Henries?

I am going to get started today, spring is around the corner.

[FOMA]

10H are in the generator.


To do winding, connected to the generator and measure the frequency and resistance. To achieve the required parameters, then make balance, do the screen.

[homefire]

If I remember right the H on that schematic means nF.

Your machine runs at 17.8 kHz

Here is some info on the Original Lobo runing at 20Khz.

Should put you in the Ball Park

[UFO]

That's awesome, thanks to both you guys. I will keep ya posted with any progress.

Yes mine is ~17.8kHz.

Pins 1 and 3 measure 5.2 ohms
Pins 2 and 4 measure 88.5 ohms

[FOMA]

27,5sm/2,54=10,8" But to 6 inches.

6x2,54=15,2sm.

Need not ellipse, but need a circle. Or may be the ring.

[UFO]

I have not given up FOMA, lol, it's just I have a hard time understanding your posts.

Specifically when you use commas instead of decimals, no spaces and different symbols. Thanks.

[kt315]

I have not given up FOMA, lol, it's just I have a hard time understanding your posts.

Specifically when you use commas instead of decimals, no spaces and different symbols. Thanks.

PLEASE give THE PHOTOS of Lobo coil ORIGINAL inside. I ask you urgently. no decimal! no spaces! no symbols! only HD photos of ORIGINAL coil with all measurements! I will give you full recomendations how to build a good coil for Lobo in the case.

[UFO]

I really do not want to cut the coil open, although I am obviously curious what's inside.

[Davor]

You may always take it to the x-ray