garret gti 2500 pinout for 7 pin plug/socket

[WM6]

shematic doesn't work, i did all thing, , but doesn't work, plzzzzzzzzzz, verify again your schematic,

Did you noticed it is REAR VIEW?

If you drove over cables by car, maybe cables was somewhere broken. Did you measure RX and TX resistance to check cable?

[prospector.hobby]

what means Rx and Tx and Gnd????

[Altra]

The drawing is correct. Verify your solder connections.

How fast was the car going when it ran over both of your coils?

Any photos of your work or the coils?

[prospector.hobby]

the car was only move over cable, not speed;
can you plz explain, what means Rx and Tx and Gnd????
and thank you so much altra; bcs i distrub you

[Altra]

TX = transmit
RX = Receive
GND = Ground or earth

Good luck, My last post on this subject

Coil data
RX coil primary - Red coax -6.54mH 8.6ohm You can't measure this because there is a 470nf capacitor in series along with two series resistors, total 1.2K

RX2 coil imaging - Blue coax - Unknown, I had a non imaging coil

TX = White coax -2.36mH 4ohms

[prospector.hobby]

thank you, i will rework again on soldering, and do all your advice, and will tell you, thank you good man