Tweet
TP4056 module inrush voltage
Good day all,
I have a power source problem using T4056 as a step up regulator to get 12v with my pickini v4 by Mr. Bernard, I already make some post about it but cant solve the problem.
Layout:
1 cell lion BATTERY---TP4056---STEPUP---MD
It will only turn on half second and off, I should repeat on and off again to get working, sometimes never get turn on.
The best working setup is to put 2w 2R resistor after STEPUP output, but it will decrease the md sens about 30%. Already try using thermistor 3R, 5R,10R not working.
With 8xAA battery its working normal with good deep, but not cute, if there any method or experience with this problem please tell me.
Arief
I have a power source problem using T4056 as a step up regulator to get 12v with my pickini v4 by Mr. Bernard, I already make some post about it but cant solve the problem.
Layout:
1 cell lion BATTERY---TP4056---STEPUP---MD
It will only turn on half second and off, I should repeat on and off again to get working, sometimes never get turn on.
The best working setup is to put 2w 2R resistor after STEPUP output, but it will decrease the md sens about 30%. Already try using thermistor 3R, 5R,10R not working.
With 8xAA battery its working normal with good deep, but not cute, if there any method or experience with this problem please tell me.
Arief