Tweet
I like the schematic symbols that are in the Express program and would like to use it.
But I am wondering when you design the PCB can you print only the copper tracks to check that its the right size for components etc,
and make your own PCB,
also does it make gerber files ?, I have looked at their website and they dont tell you much about the program
or coarse they want you to buy PCB's from them online.
I dont want to waste my time on this program only to find out later that you cannot print the copper tracks .
Any feedback is welcome, thanks.
But I am wondering when you design the PCB can you print only the copper tracks to check that its the right size for components etc,
and make your own PCB,
also does it make gerber files ?, I have looked at their website and they dont tell you much about the program
or coarse they want you to buy PCB's from them online.
I dont want to waste my time on this program only to find out later that you cannot print the copper tracks .
Any feedback is welcome, thanks.