General Electronics - Geotech Forums

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Topics	Statistics	Last Post
Hex Schmitt Trigger by ivconic Started by ivconic, 03-26-2024, 08:29 PM	4 responses 126 views 0 likes	Last Post by ivconic 03-26-2024, 10:41 PM
Junk store by ivconic Started by ivconic, 06-03-2023, 09:05 AM	5 responses 208 views 0 likes	Last Post by mts 02-29-2024, 11:06 PM
Data logger interface question for PI detectors by GeoMax Started by GeoMax, 01-31-2024, 12:32 PM	1 response 77 views 0 likes	Last Post by Carl-NC 01-31-2024, 04:27 PM
Javelin Missile guidance computer by kt315 Started by kt315, 12-12-2023, 09:06 PM	28 responses 540 views 0 likes	Last Post by Az_Ed 01-27-2024, 12:59 AM
ADC resolution increase, I bet few knew about these two facts. by Teleno Started by Teleno, 01-08-2024, 04:36 PM	2 responses 84 views 0 likes	Last Post by Teleno 01-08-2024, 06:44 PM
Chinese toys by kt315 Started by kt315, 02-17-2017, 07:26 AM	203 responses 5,398 views 0 likes	Last Post by kt315 01-06-2024, 12:19 PM
How to resize an EasyEDA 3D model in Sketchup into real dimensions - in seconds. by MDfanatic Started by MDfanatic, 12-15-2023, 08:33 PM	0 responses 69 views 0 likes	Last Post by MDfanatic 12-15-2023, 08:33 PM
Surf PI by Tripalium44 Started by Tripalium44, 12-15-2023, 12:03 PM	3 responses 182 views 0 likes	Last Post by Tripalium44 12-15-2023, 12:34 PM
"No part found" easy workaround on EasyEDA by MDfanatic Started by MDfanatic, 12-09-2023, 12:26 PM	1 response 58 views 0 likes	Last Post by MDfanatic 12-09-2023, 12:53 PM
opamp comparator tester by kt315 Started by kt315, 04-04-2018, 07:58 PM	101 responses 2,957 views 0 likes	Last Post by kt315 12-04-2023, 05:43 PM
Mosquito disintegrator by ivconic Started by ivconic, 07-04-2022, 06:33 PM	9 responses 300 views 0 likes	Last Post by kt315 11-28-2023, 09:53 PM
RIP Don Lancaster by Carl-NC Started by Carl-NC, 10-30-2023, 04:03 AM	3 responses 231 views 1 like	Last Post by Carl-NC 11-03-2023, 09:13 PM
alternative 4066 by Op04 Started by Op04, 10-20-2023, 10:19 PM	14 responses 213 views 0 likes	Last Post by Op04 10-28-2023, 12:58 PM
Magnetics ZH42206TC toroid core by ivconic Started by ivconic, 10-24-2023, 06:04 PM	18 responses 184 views 0 likes	Last Post by ivconic 10-27-2023, 08:18 PM
A small "treat" for hobbyists by ivconic Started by ivconic, 10-07-2023, 08:09 AM	16 responses 278 views 0 likes	Last Post by ivconic 10-13-2023, 05:11 PM
Cheap 500mV 1% temp compensated voltage reference circuit by Teleno Started by Teleno, 09-25-2023, 07:52 PM	0 responses 83 views 0 likes	Last Post by Teleno 09-25-2023, 07:52 PM
Gerber viewer on-line sites by kt315 Started by kt315, 11-01-2016, 11:59 AM	5 responses 157 views 0 likes	Last Post by Qiaozhi 09-23-2023, 06:49 PM
Kung Fu Flash by ivconic Started by ivconic, 08-31-2023, 08:41 PM	14 responses 171 views 0 likes	Last Post by ivconic 09-01-2023, 04:12 PM
Automatic blood pressure measurement by Orbit Started by Orbit, 08-21-2023, 10:19 AM	3 responses 89 views 0 likes	Last Post by sinclairuser 08-22-2023, 05:19 PM
E-cigs, vape pens, puff bars : Trash Tech by Skippy Started by Skippy, 05-07-2022, 12:51 PM	19 responses 531 views 0 likes	Last Post by Skippy 07-08-2023, 03:32 PM
Trail Camera quit by Mark-VA Started by Mark-VA, 05-31-2023, 12:20 PM	7 responses 156 views 0 likes	Last Post by Mark-VA 07-01-2023, 12:21 AM
MWO by Orbit Started by Orbit, 06-14-2023, 08:15 PM	1 response 79 views 0 likes	Last Post by Skippy 06-15-2023, 11:52 AM
Old 16 kbytes memory by Esteban Started by Esteban, 04-27-2023, 03:56 PM	0 responses 70 views 0 likes	Last Post by Esteban 04-27-2023, 03:56 PM
Soldering Flux - DIY by Harp Started by Harp, 08-03-2014, 09:52 PM	8 responses 288 views 0 likes	Last Post by kt315 04-12-2023, 04:15 PM
AC components by Orbit Started by Orbit, 01-16-2023, 03:31 PM	10 responses 209 views 0 likes	Last Post by Idefix 01-20-2023, 09:36 PM

Previous 1 2 3 4 5 12 24 template Next

No topics found.

Mark This Channel Read

Working...

Announcement