NEW PROGRAM ARDUINO MEGA 2560

[Vectroum]

I decide to leave 1000mm gap betwin upper and lower sensor.
I have a question about the way to handle the values that i am getting from sensors.
As i tolt you before i am using Flc-100 sensors conneted to arduino uno throogh 18bit(mcp3424) adc in order to get the values from both sensors.
I know that after getting the 2 values i have to subtract the value of the lower sensor from the upper sensor and visualize the difference in a software likeVisualizer 3d, but is that all?
What about balance? I must have to balance sensors before this process? And if yes how?

Thank you in advance.

[Krzysztof]

What about balance? I must have to balance sensors before this process? And if yes how?

https://www.geotech1.com/forums/showthread.php?16489-Carls-mag-what-you-must-know&p=111173#post111173
https://www.geotech1.com/forums/show...ibration/page3

[bernte_one]

you can balance sensors by code
first read the sensors values in serial monitor to see what values you get without changes in magnetic field
or normal tolerance

then take this as lower value

then does the sme with big iron near sensor
then take this values as upper max

for example reading 100 lowest value
biggest value 1000

then write such a code serial print if value <=110 or 150

if you have two sensors then you have to substract the values from sensor 1 and 2
and if the result is bigger or lower than a specific value it should give an output

[ricin48]

Hello.

okm visualizer 3d or any 3d management I want to decode data by a processor.

but I have no idea in which format I should send data. Would anyone like to share a document as an example?

[wtrk]

Hello.

okm visualizer 3d or any 3d management I want to decode data by a processor.

but I have no idea in which format I should send data. Would anyone like to share a document as an example?

Send me pm for not forget to send you tomorrow

[ricin48]

haha benim reis :P wphtan yazıyorum

[Carl-NC]

English please.

[zakiiuksal]

thank you

[defineci35]

This is the code they keep like a state secret
ATmega16A.txt
For detailed information, you can visit the telegram address.
https://web.telegram.org/k/#-1933840317

[Qiaozhi]

Bu, devlet sırrı gibi sakladıkları koddur
[ATTACH]n430964[/ATTACH]
Detaylı bilgi için telegram adresini ziyaret edebilirsiniz.
https://web.telegram.org/k/#-1933840317

Please read the forum rules -> Basic Rules of the Forums
and make your posts in English.

[wtrk]

This is the code they keep like a state secret
ATmega16A.txt
For detailed information, you can visit the telegram address.
https://web.telegram.org/k/#-1933840317

Hello could you please say telegram group name correctly

[defineci35]

Your channel has a ridiculous name
https://web.telegram.org/k/#-1933840317
Shortcut channel opens directly

[wtrk]

Your channel has a ridiculous name
https://web.telegram.org/k/#-1933840317
Shortcut channel opens directly

impossible to open with shortcut, many times tried it but channnel is not showing and joining