Tweet
OKM detectors
Hello good afternoon, well I have been reading the posts on this forum about OKM detectors, unfortunately most users had a bad experience with these devices, perhaps this was due to several factors such as:
They are not familiar with the handling of the equipment, non-original equipment, the operator did not know how to take full advantage of the potential of this German technology.
Because this technology is passive in itself and therefore requires methodical handling
I found highly potential targets at 14 meters deep in a sealed tunnel.
I also obtained several findings in different footages: 1.80cm, 3m, 5m, 7m all these targets were found exclusively with OKM EXP4500 Professional, different technologies from different brands were also applied:
Invenio Pro (VLF), Lorenz Deepmax Z2 (PI), Tintan Ger 1000 (LRL) and other DRS equipment. The mentioned teams could not detect those targets except one (Lorenz tested positive on the 1.80cm footage) the rest could not be detected.
They are not familiar with the handling of the equipment, non-original equipment, the operator did not know how to take full advantage of the potential of this German technology.
Because this technology is passive in itself and therefore requires methodical handling
I found highly potential targets at 14 meters deep in a sealed tunnel.
I also obtained several findings in different footages: 1.80cm, 3m, 5m, 7m all these targets were found exclusively with OKM EXP4500 Professional, different technologies from different brands were also applied:
Invenio Pro (VLF), Lorenz Deepmax Z2 (PI), Tintan Ger 1000 (LRL) and other DRS equipment. The mentioned teams could not detect those targets except one (Lorenz tested positive on the 1.80cm footage) the rest could not be detected.