Announcement

Collapse
No announcement yet.

using pipe detectors to search for gold jars

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • using pipe detectors to search for gold jars

    Hi, in my country it is difficult to get a permit for a metal detector so I was thinking of using a pipe & cables locator to find gold. the problem is I can't buy from Ffisher or Whites or any company that also makes metal detectors as it will be recognized and confiscated by customs.
    but I can buy detectors meant purely for utility like the Amprobe AT-3500 or the vivax vloc-5000.
    my question is can I align the transmitter and receiver perpendicular on a bare like the gemini 3 or similar devices? I mean to cancel the interference between the receiver and transmitter?

  • #2
    Most of the pipe locators have multiple antennae with 3 orientations so there is no way to null it with the TX.
    Tinker & Raser sells the Detectron 505 2-box locator:

    https://www.tinker-rasor.com/detectr...ng-instruments

    It appears to be identical to the Fisher Gemini 3. However, I doubt it will locate something at 1 meter unless it is very large.

    Comment


    • #3
      Try a Schonstedt GA-52CX. It uses a magnetometer. You just walk with it and wave it left and right and narrow in on your target. Is pretty sensitive. Should make a good meteorite finder…. Guys throw them in their trucks and damage the sensitivity switch. It’s a 32$ part to replace.

      Comment


      • #4
        Just a note though it won’t find gold, just ferrous stuff.

        Comment


        • #5
          This is for everyone:

          If MDs in you're country are not allowed either you could be a potential thief or the state itself.
          So first get your understanding of justice clear, finding a rusty nail might be ridiculous but
          finding the gold which the state "needs" to pay off his **** debts could be very criminal ...
          And finding golden artifacts can bring even archaeologists a huge amount of bad luck !!!

          If you are sure you won't bring yourself into big problems by "illegal gold-mining"
          it is pretty simple: Look here at the schematics section and let a friend built the
          circuit and a large coil. Give him a part of your find and hope he's trust-worthy. Hahaha

          Comment

          Working...
          X