White's IDX Pro SAT MOD, HELP!!!!!

[duggr]

I have my IDX Pro apart doing a Ground Balance and Threshold Mod and relocating the coil Connector on the meter housing.....Now all I need is just someone to point me in the right direction with the SAT Mod...Below Are some Photos of I have taken. I was told that I could either increase the resistance of r32 or increase the capacitor value of c16.Below is a Photo Of the IDX Pro CB with R32 circled in Red and C16 in RED, any help would be appreciated!!!!!!

Doug

[kt315]

I could either increase the resistance of r32 or increase the capacitor value of c16.

may be you mean to change one on the pot? thinking you need R32 change on the pot, look Hammerhead and Surf PI (that is with mods) schematics for example.
... Illinois is a state or city?

[duggr]

Does this sound right?

I think you have to look at R32,the one connected to C16
You can put a Potentiometer + a fixed resistor for a minimum value.

http://www.geotech1.com/forums/showt...&highlight=SAT

[kt315]

I think you have to look at R32,the one connected to C16
You can put a Potentiometer + a fixed resistor for a minimum value.

http://www.geotech1.com/forums/showt...&highlight=SAT

you can think what you want. I asked you about Illinois.

[Qiaozhi]

you can think what you want. I asked you about Illinois.

http://en.wikipedia.org/wiki/Illinois

[duggr]

IDX Pro Mods

Thanks Qiaozhi