Delta Pulse

[labtec1]

Hello everyone
I finally made the PCB and mount today.
Question for all that is the final revision of the list of parts ii percent do not know which is good because there are a lot in the forum. thanks

[labtec1]

[labtec1]

[szucs_g]

Is this full or demo version?

[szucs_g]

This is 2 sided version. Nice work! Congratulation! We waiting for your project ending. :-)

[koko22]

Hello everyone
can i replace diod 1n5819 Located in lcd schematic??

[jap]

Hi KoKo22
-U can,,,1N5817=1N5818=1N5819=BYS21=BYV10-,,,, OR any Schottky diode.
best time
j.

[labtec1]

KT315 might have something to say?

[labtec1]

Did you mean: опрости ој енглески је врло лош па користимprevodilac


Allow phonetic typing

[COLOR=#222222 !important]






[/COLOR]
Serbian


English


Spanish




forgive our English is very bad, so I use translated

[kt315]

KT315 might have something to say?

you will get a real fun making DP! good luck!

[koko22]

Thank you very much jap

[Nicolas]

Hi Jap

I need your help

I build coil 40 cm two wire x12 tur 0.5 mm R=2.7 Ohm 0.580mH
R5 = 2.2k 1/w
IRF 740 is hot
and I test coil not detect small parts only 40cmx20cm parts

What the problem?

[labtec1]

whether someone can pstavi final version of the PCB and parts list, since a lot of them here, and I do not know which one is best.
or make all and then see what works best
thanks for answers
greeting

[jap]

Hi Jap

I need your help

I build coil 40 cm two wire x12 tur 0.5 mm R=2.7 Ohm 0.580mH
R5 = 2.2k 1/w
IRF 740 is hot
and I test coil not detect small parts only 40cmx20cm parts

What the problem?

Hi Nicolas
-Bad coil because the type of wire is ~ not Copper.
-try CAT5 .
best time
j.

[Nicolas]

Hi Nicolas
-Bad coil because the type of wire is ~ not Copper.
-try CAT5 .
best time
j.

Hi Jap

Ok I'll try another type of cable
thank you and if I find another problem. I contact you

Note: I soldered the IRF 740 in the first place upside down, but after I put it right
if you thought that any defective component or

Best Regards
Nicolas