Delta Pulse

[kt315]

hi kt315 and anybody
any body work by 110*110 cm in wild land or soil or mountains .
i want understand have good stability and good work in real ????
i just test in air.
regards

you have to ask bulgarians. I have not such conds around. mine wild land is neutral anywhere. I was in Bulgaria,
do not know as for hunting, but the ground is really hard anywhere.

[kt315]

ahhhhhhhhhhh
in my country have not graphite spray. so i should use Al foil .
regards.

much russians use 'copper-graphite collectors' using for trolley-buses. on terminal end stays you can find them used huge much, trolley drivers throw them away like a garbage. then mill them on any abrasive and you get the copper-graphite powder. russians do not buy the special conduct spray.

[kt315]

[kt315]

[kt315]

[kt315]

[kt315]

[mohandes]

many thanks KT315.
i finish my new DP2 analog pcb and know just want finish discrimination pcb.

I have Diesel Generator , it have many Coal like this :



so i Shave Coal and put like you.just i should Composition any Materials like water or no ?
best wishes.
i put here lot picture and data about my Experience.
regards

[calebsone]

I think you need to mix it with varnish or epoxy resin I used the inside of batteries and graphite pencils for drawing they are square with no wood it makes good shielding.

[kt315]

varnish ll be good, you have to find needed varnish. maybe bitumen or on bitumen base.

do NOT USE polyvinyl chloride resin -!!! PVC KILL A CONDUCTIVITY!

[kt315]

[mohandes]

hi dear Kt315
do you know this schematic for DP?it is work or no
regards
New folder.zip
edit:
i wrong it is not DP.

[mohandes]

hi all
i finish another dp2 and use stth12r06d diode.work but not test yet.
but in lcd i have not character ???'
so i try tomorrow .
regards

[mohandes]

Hi Nicolas
File HEX for the descrimination of PIC 18F252 new version.
best time
j.

hi
this version is ok?
i have problem with this program ?
regards

[mohandes]

hi
this version is ok?
i have problem with this program ?
regards

when i want program have massage : have some error but can program , when put the PCB dont LCD dont have character .
excuse for my English.