Ground balance

[Jose]

my measurement result
[ATTACH]57613[/ATTACH]
[ATTACH]57614[/ATTACH]
[ATTACH]57615[/ATTACH]
[ATTACH]57616[/ATTACH]
[ATTACH]57617[/ATTACH]

[ATTACH]57618[/ATTACH] glue can only 25cm.

The measurements, first, second and fifth, look good.
I don't understand the question on the third and fourth measurements.
In general I would say that the time base is fine.
In my opinion, the problem of low sensitivity should be looked for elsewhere.

[Jose]

[ATTACH]57619[/ATTACH]
[ATTACH=CONFIG]57620[/ATTACH][ATTACH=CONFIG]57621[/ATTACH][ATTACH=CONFIG]57622[/ATTACH][ATTACH=CONFIG]57624[/ATTACH][ATTACH=CONFIG]57625[/ATTACH]

We have discussed a lot in the past about the GS4 issue, today we see clearer some doubts that we had then.
The biggest problem I had was noise and instability, which was due to the PCB design, the 1nf capacitor helped but was not the cause.
GS4 is a good detector, it uses a wide TX pulse, I set it to 250us on mine, also with a double key I modify the response time of the integrator to be slower, this way you can go deeper into the size of objects search. .
I always say it, the PaPa Alax scheme is exact, it is a reliable scheme that helped me to order the sequence of the pulses in the GS5.
Very good construction of the coils, good work.

[pustareka]

Thank you Jose. You are big GoldScan master Argentina. I enjoi yours videos.

[Bayu]

The measurements, first, second and fifth, look good.
I don't understand the question on the third and fourth measurements.
In general I would say that the time base is fine.
In my opinion, the problem of low sensitivity should be looked for elsewhere.

thanks jose, last night for about 5 hours I was fiddling with the gs5, and I found to increase the detection distance by increasing the opamp's fedback resistor, but another problem came out, namely GB still reads high for bricks, and the sound difference is missing. what part should i change? because this is the first time I'm doing 4channel sampling, that's why I'm still confused

[Bayu]

S2-all should be 200us after S1-all, the same as between S1-geb and S2-geb. It will work with a shorter delay but will reduce depth and Earth field cancellation may not be as good.
I don't know what A and B are for but it looks like the delay between them is set by R62 and C26. The delay between C & D are set by R60 & C24, so the A-B delay should be the same as the C-D delay. If these correspond to the S1-S2 pulses then that would be correct.

hello master carl! the other day I read your comment about the timing setting, and members called it GB carl, but I forgot the title of the post, at that time you gave an overview of the timing setting for 4 ch

[Bayu]

I put the timings according to gs5 and this is the result, but the difference between FE and NON FE can't. where is my mistake please guide

[Carl-NC]

Try a lower conductor target like a small (25mm square) piece of foil. See if you can find anything that gives a high tone.

[Bayu]

Try a lower conductor target like a small (25mm square) piece of foil. See if you can find anything that gives a high tone.

I tried many targets but I didn't video. like thin small coins, foil, gold and others, but the tone is all the same, all metal or GB settings, I use the timing setting as shown below.

[Carl-NC]

S1-all and S2-all should be spaced 200us apart, just like S1-geb and S2-geb.