Bandido II SMD (PCB)

[Hink]

The printed circuit board is verified. I did not manage to achieve more than 5-7 cm per coin, but it was a problem in a thick wire(twice as thick). Discrimination works. The board is fully tested and working. It was drawn for commerce, but I decided to draw the campadre for commerce. Added a volume knob. All regulators are displayed only on the board on the reverse side. Feel free to repeat it. Thanks for attention. I am from Russia(Crimea)

https://dropmefiles.com/hmoaS

[Hink]

here is the archive with the PCB file

[Op04]

Dear Hink,
Thank you for sharing here

[Hink]

on health

[Phantom]

Hink, thank you for share the project.

It could be interesting a bill of components and the serigraphy of them in the PCB

Is it possible?

Regards

Phantom

[Hink]

Hink, thank you for share the project.

It could be interesting a bill of components and the serigraphy of them in the PCB

Is it possible?

Regards

Phantom

when you hover over the elements, their nominal value is shown

[Hink]

Here is the sine on TH.Unfortunately, the counter 4024 died (there is no generation of the meander), although everything worked before that. Perhaps the problem was in the faulty 4024 initially. In addition, I initially confused the polarity when I first turned on. And the meter is powered directly from the stabilizer.

[Ruben2000]

Hi Hink, good job. Could you post the schematic to an image file to make it easier to download?

[Hink]

Hi Hink, good job. Could you post the schematic to an image file to make it easier to download?

hold

[Toros]

when you hover over the elements, their nominal value is shown

Not all items are displayed. You need to look for elements in the links of the scheme!

[Hink]

I apologize. only the stabilizer 2931 and diodes are not displayed. All diodes are 1N4148(9). On the diagram, the symbols are arrows (from the anode to the cathode, respectively)

[Koala]

I built the SMD Bandido II umax of the Russian forum and used it for about a year

works as expected

true no motion is excellent.

5.5" concentric coil gives 10" in the ground an a pre decimal 1/2 penny (UK)

board was from silverdog although I took the last one.

[Hinkri]

Someone assembled according to this scheme? share the results. thanks.

[Hinkri]

I forgot to write why I had only 5 cm per coin, then when parsing, it turned out that the denominations did not match, the problem was an excess of phosphoric acid, all the details were saturated with this acid, and lost their denominations.Sincerely.