If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The correct Radio-Shack model number should be 63-3006 or even 630-3006. If this model uses 3- 9 volt batteries , and you have ferrous-non ferrous on your analog meter it is a 63-3006 !!! If it uses 6 AA batteries it is another model.......So the model number 63-3003 , I posted above is wrong !!!!!!See the little notepad with the correct specs , and sorry for my earlier error on the model number.
Esteban ,After you solder the new inductors in place. With the batteries not connected turn on the unit , then all the controls mid-range , take an ohmeter reading with your DVM across the battery terminals , make sure nothing else is shorted before you re-apply power. As you can see the specs say 30-35 milli-amps is normal , anything much higher is not good. Anyway, you also have Excellent electronic troubleshooting knowledge ,so you will not have any problems repairing this Detector............Eugene
Thank you for the table with the characteristics of this device.
Tweet
Comment