If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Detector test your coins to 8 inches, is to use the headset test it?
Or use the buzzer or a meter?
You used the power of detection. The maximum energy to the number of volts?. LT1054. ICL7660 can be used instead?
Most of the time, I just listen to the piezo speaker.
Sometimes I watch the Meter as it can be More Sensitive ** than the sound from the Piezo.
(** If you use my Expanded meter circuit)
I Never use Headphones.
The LT1054 and the ICL7660 are both Simular.
They do NOT Determine the Sensitivy or power capability of the metal detector.
They only create a Positive supply to operate the TL081's.
Most of the time, I just listen to the piezo speaker.
Sometimes I watch the Meter as it can be More Sensitive ** than the sound from the Piezo.
(** If you use my Expanded meter circuit)
I Never use Headphones.
The LT1054 and the ICL7660 are both Simular.
They do NOT Determine the Sensitivy or power capability of the metal detector.
They only create a Positive supply to operate the TL081's.
The problem of low detection has been found, the problem is the speaker, for a telephone handset. sensitivity substantially. Detection of coins 20CM. testing 40 * 40CM iron to 1 meter.
I IC9 replace AD811 sensitivity increases a lot.
The problem of low detection has been found, the problem is the speaker, for a telephone handset. sensitivity substantially. Detection of coins 20CM. testing 40 * 40CM iron to 1 meter.
I IC9 replace AD811 sensitivity increases a lot.
IF you had Bought the Kit of parts from me, You would also have the Proper Speaker for my detector and you would have gotten Better Sensitivity from it.
The problem of low detection has been found, the problem is the speaker, for a telephone handset. sensitivity substantially. Detection of coins 20CM. testing 40 * 40CM iron to 1 meter.
I IC9 replace AD811 sensitivity increases a lot.
Previously I never bought any of the AD811's Because of there Somewhat Expensive Cost.
But I just bought 16 of them now at what I believe is a GOOD Price. ($3.35 Each)
(Also with a Reasonable Shipping cost.)
So when they Arrive, I will do some testing with them.
And It would also be better if you could properly set the DC Offset to near zero volts or just slightly above that.
But that would require some changes in the circuit for this IC.
Hi , your Gary pulse a circuit. Can two IRF840 in parallel with it?> detection will increase?
.
You can, if you wish, with some protection mod, but detection depth will not increase, except if you use two TX coils. In other words: you can double TX current by using only one IRF too.
Comment