Announcement

Collapse
No announcement yet.

Surf PI Pro

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • The Problem When I Connect the Coil IRF9640 Going Hot
    Witout Coil The IRF9640 is normal

    Comment


    • I attached a heat sink on IRF9640

      Comment


      • the irf9640 it can not be to hot if the board dont have problem

        Comment


        • thanks for answering my questions
          Now My Board Is Working

          Comment


          • Hello for the benefit of others, would you write what your problem was and how you found it? thank you.

            Comment


            • The Board Jumper Is Not Connected

              Comment


              • and now you ake a goood coil and Show us your results

                best regards

                Comment


                • yea i am forgot i must share here!

                  Comment


                  • i have try coil for surfxx
                    mono coil size 18CM my inductance is 0.210mh
                    wire thiknes is 0.49
                    Resistance 02.0
                    1euro coin i get 30cm

                    Comment


                    • Originally posted by paku View Post
                      i have try coil for surfxx
                      mono coil size 18CM my inductance is 0.210mh
                      wire thiknes is 0.49
                      Resistance 02.0
                      1euro coin i get 30cm
                      yes ok thats goood and enough - stable 30cm

                      got some very cool shells from stefan stefanov (mikron)
                      if you can get them try them
                      https://sites.google.com/site/detekt...cm%20Spule.JPG

                      Comment


                      • Originally posted by bernte_one View Post
                        yes ok thats goood and enough - stable 30cm

                        got some very cool shells from stefan stefanov (mikron)
                        if you can get them try them
                        https://sites.google.com/site/detekt...cm%20Spule.JPG
                        huhuh yea thanks
                        bernte_one

                        Comment


                        • Can i used a polarized capacitor in C7 which is 1uf stacked capacitor ?? Or is ther any alternative for it? Because I can't find a stacked capacitor in my place.

                          Comment


                          • Hello if your asking about the Surf PI 1.2 pcb capacitor C7 which is 470nF, which is small and quick when passing AC, using a 1uF will take the signal approximately twice as long to charge and discharge the cap, I do not think it will be good.

                            Comment


                            • Hi kenny444.. i mean the c7 of surf xx..anyway i made my surf xx working now..i just used an electrolytic cap instead of 1uf stacked cap..

                              Comment



                              • With LED Detection

                                Comment

                                Working...
                                X