garrett deepseeker ads vlf/tr

[wolff1]

hello to all.
I am new to this site and hunting as well. here is my problem, i have inherited a garrett deepseeker as mentioned in the title, anyways as it goes i did not have a battery tray included for this unit. so i decided to build one from scratch. I have noticed that only 4 wires are actually used on this machine and am wondering about all the other 2 pins,do theygetconected to the board as well or can i just use the 4 i have connected and ignore the other 2 pins? does anyone have a good photo of the original battery tray for this machine?

[mikebg]

Search the site and see this:
http://www.geotech1.com/forums/showt...ght=deepseeker

[scs]

RM1 and CM1 make phase shift a receiver signal.
Professor scs

[scs]

And the stabilizer will not always start..
Professor scs
[ATTACH]23676[/ATTACH

[wolff1]

thanks for the mods to the machine. but i am looking for the original battery tray schematic for this one. i have built one but need the soldering schematic. thanks in advance.

[johnandles]

thanks for the mods to the machine. but i am looking for the original battery tray schematic for this one. i have built one but need the soldering schematic. thanks in advance.

[wolff1]

thank you for this. i have figured it out. so far so good. just a lil softening of the solder joints and i will be ready to try it out. thanks agin.