How do you remove the s-handle couplers?

[SVEN1]

I want to use this Garrett coupler on another s-handle.
Just don't know how to remove it.
Is there a simple way?

[kt315]

Sven, it is of Minelab thinking is similar.

[SVEN1]

Thanks

That was easy.
Just had to be a bit careful prying the cap off as there was some adhesive holding the cap snug.

[kt315]

my problem was to glue a coupler cover back. material is specific plastic and not glued by a PVC glue and dichloroethan. finally I used an epoxy.