Help needed. the cable was twisted and all the wires broken from the pins. this is the box end of cable. does anyone know which wires go to which pins? there are two seperate internal cables with two wires each one is a red wire and bare wire- one is a clearcoat wire and bare wire. the bares do have some black rubber protectant on the ends for about 1/4 inch. so one unused pin.
i think pin 3 was not used. anyone know which goes where i appreciate it. i can epoxy fill the plug and put a new boot and salvage this one i believe.
and for once i did not break something!
thanks [email protected]
i think pin 3 was not used. anyone know which goes where i appreciate it. i can epoxy fill the plug and put a new boot and salvage this one i believe.
and for once i did not break something!
