need help for a 1280 aquanaut

[rolund]

Hi everybody !

This my first message here.

I need help for a 1280 aquanaut. This one don't emit sound, so i have tried to open it and i pull to much the front panel. Two wire are disconnected, one white and one violet from the board to the led of the front panel.
But i can't see where they was soldered before. Anyone have an idea ? And so on why there is no sound ? Just before i opened, the led flashing when a metal was under the coil, but with no sound ...

[kt315]

hi, I did see two variation of PCB in 1280, thru hole and SMD. what your PCB? can you give pics?

[rolund]

Thanks to answered me, but i can't join (post) picture. I can send one by email. i have seen a number on the board h 43-89.

Have you one or two pics ?

[Silver Dollar]

Try this;

[rolund]

Thanks guru !

hum, i suppose the front panel led is connected to the resistor R602 (60 ohm) isn't it ?

[kt315]

[kt315]

[kt315]

I can send one by email

my email address [email protected]. please in high resolution at sunny day pics, both sides.

TIA

[rolund]

Thank you very much for your help.

The front panel led works. The Headset doesn't works. I don't know how to open it...

I have tested the the stereo out with a small speaker and it's ok.

I think i will change the headset for a wire and 6.35 jack embase.

[sinclairuser]

i have only ever seen two of these in the "wild",both had been fitted with headphone sockets.