idx pro files

[giuseppem94]

I would like to build a idx pro, I read some parts of the great discussion, but I could not find a file that includes all the material, I found this, it is updated, does it work?

IDXpcbback.zip

[Silver Dollar]

It is confusing. I finished my IDX but it's unclear how to wire up the pots and switches.
I have this drawing but it's a bit different from my Silverdog board;


I have files like below with everything in one. I thought I'd be smart and put the missing stuff
like the picture above in the zip but it doesn't match so I'll leave it as originally found...

[Silver Dollar]

Right here there is a slight difference. I think there should be a stand up 100k and
then 2 wires for PP but originally I thought it was for a 100k pot...

[Silver Dollar]

These right angle pot connections are a bit funky too;

[Tibuck19]

These right angle pot connections are a bit funky too;
[ATTACH]31160[/ATTACH]

Thanks it was helpful, P5SW is just a Off and on switch ? where is the all metal and Discrimination switch ? r unlike the TGSL there is none and its in all metal when the PP switch its on ?

[Nandor]

Hi
Yes P5 is On/Off. IDX has no disc switch, All metal mode is Disc pot at minimum or Pinpoint mode.

[Tibuck19]

Hi
Yes P5 is On/Off. IDX has no disc switch, All metal mode is Disc pot at minimum or Pinpoint mode.

Thanks, I will wire it up with a double throw switch, on1 will be power and pp aka all metal and on2 will be power on and normal just like I have the tgsl wired up.