Simple Russian PI detector Pirat

[BKY1337]

What is an experimental model? Is the Op amp wrong?
How much costs a barracuda board from you? Im not sure if i need a barracuda board because its just for a little pinpointer and
i have all parts here for the pirat.

The barracuda in the video works very good.

[kt315]

opamp is not wrong. what he had have that he did set. trash.
Bara pcb 12 euro. you CAN do pinpointer from Bara. no problem. if you will supply from 9V batt 6F22
only decrease PULSE WIDTH to 10-20us.

[homefire]

I did one of kt315's Barracuda boards. TOP NOTCH! You could always revert it to a full size PI Detector any time too.

[BKY1337]

Ok , i will make the russian first and then i will see how good it is.

What is the difference between yours and silverdogs version?
Do you have the ics for the barracuda too?

[homefire]

Mostly Board Lay out. Through holes are a bit larger easier to work with. What version of the Pirate are you doing ?

[kt315]

ok i see you Germany and like all russian.... then this

https://www.youtube.com/watch?v=GcVpVrle9WI

[BKY1337]

Lol,.



Im doing the easier pcb with the 2200 uF electrolytic capacitor. The green and black layout picture from the site.

https://www.youtube.com/watch?v=FsBIR41amtU

I just saw that people are using different electrolytic capacitors and different pots.

Its the only one that i have with the russian ic. The other ones use TL072 and the layout is different.

By the way: Can someone please open the sprint layout file with a russian version because i cannot open it with mine.
Or is it damaged?

[homefire]

Post a Link to the file here and I will see if I can.

[BKY1337]

https://www.dropbox.com/s/2p643h2xs6...D1%85.lay?dl=0

I have the same problem with the sPlan viewer file. It seems that the problem is the russian font.
I dont need the parts names just the layout.

Its not important by the way, because its a very simple layout.

[homefire]

Well my Lay viewer does not recognize it.

[RH-Lightning]

just rename the *.lay with latin letters and it works.

[BKY1337]

Ok , thanks, it worked, i needed to change the names of the folders too.
But its not the layout which i wanted to make. Same parts and size but different layout.
Its not important because i will use a stripboard.

The layout file is without NE555 , maybe another version.

Do you think i can replace the BC547/548 to BC558 and BC548 ? Or can i use 2N2222A? I have a few left.

[RH-Lightning]

I have an SMD layout with Tl072 and ne555. + spl7 +schematic.
do you need it?

[homefire]

I have a Butt Load of Pirate stuff. Maybe one of these ?

[BKY1337]

Homefire its none of these.

Yes i wanna see the smd layout.