Tweet
Quick quiz gents, got the discriminator module from crazytech and all works with the detector fine but the instructions are a little unclear as too setting the voltage.
I have set it as low as it will go 1.98v and it work but the disc goes mostly straight into full so does anyone know what voltage it should be set too ideally (the battery pack voltage or lower ?) or too match one of the voltages on the board out puts etc?
I have set it as low as it will go 1.98v and it work but the disc goes mostly straight into full so does anyone know what voltage it should be set too ideally (the battery pack voltage or lower ?) or too match one of the voltages on the board out puts etc?
pmsl
Comment