Ivconic, if you've got the time.

[dbanner]

I know you can't resist, since you are best known expert here on forum with Sprint layout creator.
This should be peanuts for a man with your skill with this software. I did much work, and it is almost complete. Rather than have it languishing in some corner of my hard drive, maybe some one can benefit.

[ivconic]

I am not familiar with that, what is that?
And what are you asking me for?

[dbanner]

My apologies, I forgot to put the photos of the board and also the cropped photo I used to trace it out. It is one of Mr. Foster's underwater pulse machine. I can put the component values after the foil has been completed. I just ran out of patience on this one.

[walkman]

as much as i can see

[dbanner]

as much as i can see

I'm unable to open the file, Winrar says it is unknown file or is damaged.

[walkman]

Reloaded zip format

[dbanner]

Reloaded zip format

Great work! Thanks for helping, now I'll complete the layout by putting the component values and finishing up whatever little remains to be done with the foil. Good of you walkman. Splendid!

[walkman]

Great work! Thanks for helping, now I'll complete the layout by putting the component values and finishing up whatever little remains to be done with the foil. Good of you walkman. Splendid!

[kt315]

Nelson,
i again remind you about your promises to give HR pictures of the board.

Nelson Lepe <[email protected]> wrote on 30.10.2014:

Hello Anatloy

Well i was a little busy with lots of things in mind [WASTE???? we are also busy and WHAT? we do our job here HARD!] and also to much work to do. It will be nice for me to have full of my time to work on metal detectors, but unfortunally i have to work, be incharge of my family and also taking care of my wife health that now is much better. So far i will try to get new pictures from aquapulse and then i will send it to you.

About Whites TDI, do you have the schematics for it?

Thanks for taking the time to write me and i will be back has soon has i can take the pictures.

Best regards

Nelson