If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Troy X3 Carl.
I use the 9 inch coil.
However I have the same results with the stock X3 7" coil which is pretty amazing.
You have to get in a little chatter to get 15 sometimes (in the house) but 14 is easy.
I'm going to re-do this with the 3 coils I have (9, 7 and DD 10 x 5) and with a uMax for reference.
Troy X3 Carl.
I use the 9 inch coil.
However I have the same results with the stock X3 7" coil which is pretty amazing.
You have to get in a little chatter to get 15 sometimes (in the house) but 14 is easy.
I'm going to re-do this with the 3 coils I have (9, 7 and DD 10 x 5) and with a uMax for reference.
Unfortunately, that 15" turns into about 6" in many cases in actual use.. It seems as though these higher frequency machines are really hot on small, low conductors but don't penetrate so deeply in the ground. At least that is my observation withe the X5.
Comment