MD-5008 Help

[metaldetector107]

Hi all
can anyone tell me how to reset MD5008 metal detector
because its detection very poor
any help will be appriciated
thanks again

[kt315]

is the RESET button not working? MD5008/5006 is deep detector, but only in ALL METAL mode. in DISC mode it is paly on depth.

[metaldetector107]

MD-5008

Dear kt315
i just bought it yesterday i dont know how to operate the manual is in chinese about reset doesnt have reset button.
you said its not good in Disc mode?
its realy bad news

[Qiaozhi]

Dear kt315
i just bought it yesterday i dont know how to operate the manual is in chinese about reset doesnt have reset button.
you said its not good in Disc mode?
its realy bad news

Please scan in the manual and post it here.

[kt315]

I have the manual but in russian only. will it be help?

[rospy]

I have the manual my friend,but in greek only.




If you want....



.................................................. .................................................

[metaldetector107]

MD-5008 Help

Dear All
thanks for all of you, actualy i have the manula in english downloaded
but my problem is
i have to coils 25cm and 33cm
with small coil it looks ok but when connecting 33cm coil you have to set Disc on minimum otherwise doesnt detect,when trying to zeroing at max Disc i can not any help
thanks again

[kt315]

Dear All
thanks for all of you, actualy i have the manula in english downloaded
but my problem is
i have to coils 25cm and 33cm
with small coil it looks ok but when connecting 33cm coil you have to set Disc on minimum otherwise doesnt detect,when trying to zeroing at max Disc i can not any help
thanks again

interesting... when MD-5008 with both coils was in my hands, I measured resistances of RX and TX windings and the resistances seems were another as if RX and TX were been exchanged in big coil... but I did not test the md with this big coil at a field. so... try to measure these ones...