Tweet
Got a prob with my Euro Sabre at the mo.
Can anyone help with the info regarding the threshold control needed. The white wire has snapped off where it is soldered on. Which control pot do i need please,and where's the best place to buy from?
Also. I have an 8 1/4" widescan fitted to it. The ferrous disc is fine with the ferrite rod. But when an 8 1/2" widescan is fitted and the ground control set in fixed,the ferrite wont be disced out,unless the ground pot is put in manual and turning the ground control up till the ferrite rod is rejected. But i would rather trim the 8 1/2" widescan into the fixed setting more than the other coil. Anyone know which is the trimmer for this please. There is a trimmer near the bottom of the board on the right,and one near the top right with 2 smaller white trimmers along side it.
Any help would be great
Can anyone help with the info regarding the threshold control needed. The white wire has snapped off where it is soldered on. Which control pot do i need please,and where's the best place to buy from?
Also. I have an 8 1/4" widescan fitted to it. The ferrous disc is fine with the ferrite rod. But when an 8 1/2" widescan is fitted and the ground control set in fixed,the ferrite wont be disced out,unless the ground pot is put in manual and turning the ground control up till the ferrite rod is rejected. But i would rather trim the 8 1/2" widescan into the fixed setting more than the other coil. Anyone know which is the trimmer for this please. There is a trimmer near the bottom of the board on the right,and one near the top right with 2 smaller white trimmers along side it.
Any help would be great
Comment