Delta pulse LCD display

[6666]

Tomari
what was the software you used ?

[tomari]

hello i used winpic800 but it doesn't matter u can use mplab ore anything else just go to asci view and select the right pic you will see the text for excample "LOADING" you will see "0L 0O 0A 0D 0I 0N 0G" etc

[szucs_g]

To describe for you how to configure the DP either of LCD display? Do you have documentation? Thank you!

[szucs_g]

I have uploaded the hex file to Geotech1 as the other link not working.

I uploaded the English version in the pic. The signs on black letter P appear as. Can I change this? Unfortunately I can not be programmed. :-(

[szucs_g]

I uploaded the English version in the pic. The signs on black letter P appear as. Can I change this? Unfortunately I can not be programmed. :-(

Right. Then I answer myself. Compared the two hex file. I found the "signal" after the characters are drawn in the status bar. I changed the original. I like the original Turkish, but English initial screen. :-) Now looking for a black character that is not mocking the "P" to indicate a hit.

[freedan3d]

help me uykusuz

Hi elbombaci or uykusuz
I make your delta pulse and your lcd circuit too
I adjust multi turns and its work very well
Great job my master

My delta detect a silver ring(2.8 g , 21mm) about 30 cm in air(in room)

But my lcd board's green led always is on and when it detect any object red led turn on

is it havent discriminator?

[maximusdesmus]

I have lcd module and programmed pic controller but i cant figure out which wire out of 5 on the module goes on what point on the board, there are points A,B,C,D and E on the schematic for connecting the module but which wire on module is A that is which one goes to the 4th lm555 leg?

thank you in advance any explanation or picture would help me connect it.
p.s. i built the turkish one sided pcb from teknolojiekibi here is the picture of my delta pulse with 27cm coil i detect one euro coin 28cm in air clear signal and golden ring 25cm in air.

[maximusdesmus]

no need for help i found schematics on turkish website and i connected it it works fine, except for even small signal bar graph is full now
i need help for fixing the signal strenght and bar graph size

[maximusdesmus]

fixed.