A few weaks ago I bought a OKm Rover CII. I wanted to find some tunnels and cavities, but after we checked certain areas we found out that the device canĀ“t pick up signals of tunnels deeper than 3m. We went to a cave we knew and used the CAVEFINDER function. Result: CAVE=NO! Then I went to another cave-same result.
The next step was to go to a tunnel we knew and scanned it with the "GROUNDSCAN" function. We expected to see a greenish bit (solid ground) then a bluish bit(tunnel we crossed) and afterwards another green part! But we saw at the VISUALIZER 3D software just blue dots,lines. Some yellow and green parts. We did several scans-always the same result!
Now I found your forum and read that OKM is crap:-((((
Could it be that I did some mistakes or is it just because the machine is so bad??????
Is here someone who had the same problems, or has someone tried an action against OKM???
The next step was to go to a tunnel we knew and scanned it with the "GROUNDSCAN" function. We expected to see a greenish bit (solid ground) then a bluish bit(tunnel we crossed) and afterwards another green part! But we saw at the VISUALIZER 3D software just blue dots,lines. Some yellow and green parts. We did several scans-always the same result!
Now I found your forum and read that OKM is crap:-((((
Could it be that I did some mistakes or is it just because the machine is so bad??????
Is here someone who had the same problems, or has someone tried an action against OKM???
Comment