Puls star 2

[Orbit]

Is there any chemicals to clean the module pulse star 2 of Araldite resin to refrain to reach parts ,I would refrain to improve oscillator.

[kt315]

hi Orbit, I used a paint washer for epoxy resin deleting, very good effect there. try use anything like this epoxy dissolver Glue Resin adhesive cleaner http://cgi.ebay.com/Attack-epoxy-dis...item2a01bbf2fd

I know nothing about it but may be anyone in CONUS can tell you more.
you are in course... my native is not Spanish...

[Orbit]

Thanks kt315

[kt315]

I did this to demonstrate how it works... in one russian radio DIY forum... can look... this FBT from TV set was been taken for the breakdown.
a debate was been won by me!

[aft_72005]

Hi KT315
About pulsestar2 , aban having circuit ,. I remember the place of this forum , there are
Picture of PCB uploaded by aban.
There isn’t big advantage with pulsestar2 . it is ordinary PI detector . it is not hi deep detector!! .
When work at discrimination mode Decrease 30- 50% detection deep!!!

Best regards.